20 20 Fusion Advance Graphic-tem remove

To Parent Forum

- April 11, 2017 at 12:52 pm #124881
  MTC MTC
  Participant
  Why they remove some item for 2020 fusion in advance graphic specially the snap point there no item for pointing the exact location for example pipe. or wire for electro-mechanical work i hope make update for advance graphic catalogue and back the some item..or add additional for this issue
  
  thanks.
  
  Attachments:
  Untitled.jpg
- April 12, 2017 at 11:06 am #124961
  
  Jim Smalley
  2020 Moderator
  
  Hi ‘MTC MTC’,
  
  Yes, indeed, the ‘Snap Point’ item is very useful for the situations that you describe.
  
  I have just checked the latest copy of the Advanced Graphics catalogue and the *SNAPPOINT item is still present. Please can you make sure you have the latest copy of the catalogue and check again. If you still have a problem with finding this product in the Advanced Graphics catalogue, please contact the Support Team for further assistance.
  
  Regards,
  
  Jim
- April 12, 2017 at 11:46 am #124971
  
  MTC MTC
  Participant
  
  thank u for reply sir jim yes i reinstall the old cat. for graphics
  
  a lot of door and some decorative item that i need at the old graphic in the new one i hope they put a option to install the old and new graphic same as worktop catalogue old and new..
  
  thanks
  
  regard
  
  Ernesto.
  
  Designer of Mtc

You must be logged in to reply to this topic.

Topic TagsAdvance Graphic snappoint