[Glenn Christy]

I’m doing a design where I’d like to take a W942 cabinet with the face only and put it above a refrigerator as a filler (42″ wide vs. 42″ high).  I’m assuming I use “Attachment Angle” in the attributes to do this but when I change x, y or z angles nothing happens.

Is there another way to do this?

[Mike Cook]

Use the general Attributes to change the height to 9″ width to 42″ depth to what you need.

[Mike Langensiepen]

Just FYI, if anyone needs angled fillers/panels, the UNDRGRND catalogue has an Oak Beam which can be rotated to any angle on the XYZ planes and you can change all the dimensions and finish. This will allow you to create an angled filler/panel.