[Chris Blackman]

Sometimes I will take 1 cabinet that I know I want to repeat several times in a design, configure it properly (handle placement, finished sides, up/down ,etc) and then duplicate it (right click the cabinet). Everything comes out just fine except if I adjust the up/down setting and that always goes back to the default setting for the object I duplicated. I.E. set a wall cabinet to 4.5″ above the floor or a base cabinet to 34.5″ above the floor. The duplicates end up at 54″(0″) or 0″(0″).

Anyone else have that happen?

[Mike Langensiepen]

Use Copy and Paste rather than Duplicate. Duplicate takes the default up/down, in/out etc set for the original unaltered item. Copy and Paste takes the settings for the altered item.